D-Link 5000 Series, Справочное руководство CLI

Страница: 1062 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1056
interface must also be specified.
autodetect interface
interface-name The routing interface on which the neighbors link local iPv6 address is
auto-detected.
retty-time The number of seconds to wait before attempting to establish a TCP
connection with a neighbor after a previous attempt failed.
Default
The default is 2 seconds.
Command Mode
•
BGP Router Config
•
IPv4 VRF Address Family Config
•
Peer Template Config
11-50 neighbor connect-retry-interval (IPv4 Address Family Config)
Use this command to configure the initial connection retry time for a specific neighbor. If a neighbor does
not respond to an initial TCP connection attempt, D-LINK OS retries three times. The first retry is after the
retry interval configured with neighbor connect-retry-interval. Each subsequent retry doubles the previous
retry interval. So by default, the TCP connection is retried after 2, 4, and 8 seconds. If none of the retries
is successful, the adjacency is reset to the IDLE state and the IDLE hold timer is started. BGP skips the
retries and transitions to IDLE state if TCP returns an error, such as destination unreachable, on a
connection attempt.
Issue this command in Peer Template Configuration Mode to add it to a peer template.
Use the no command to reset to the default the initial connection retry time for a specific neighbor.
neighbor {ip-address | autodetect interface interface-name} connect-retry-interval retry-time
no neighbor ip-address connect-retry-interval
Parameters
ip-address The neighbors IP address.
autodetect interface
interface-name The routing interface on which the neighbor’s link local iPv6 address is
auto-detected.
retry-time The number of seconds to wait before attempting to establish a TCP
connection with a neighbor after a previous attempt failed.
Default
The default is 2 seconds.
Command Mode
IPv4 VRF Address Family Config