5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1098
no timers bgp
Parameters
keepalive
The time, in seconds, between BGP KEEPALIVE packets sent to a
neighbor. The range is from 0 to 65,535 seconds. Jitter is applied to the
keepalive time.
holdtime
The time, in seconds, that BGP continues to consider a neighbor to be
alive without receiving a BGP KEEPALIVE or UPDATE packet from the
neighbor. If no KEEPALIVE is received from a neighbor for longer than
the hold time, BGP drops the adjacency. lfthe hold time is set to 0, then
BGP does not enforce a hold time and BGP does not send periodic
KEEPALIVE messages. The range is from 0 to 65,535 seconds.
Default
The default keepalive time is 30 seconds. The default hold time is 90 seconds.
Command Mode
•
BGP Router Config
•
IPv4 VRF Address Family Config
11-105 timers policy-apply delay
This command configures the delay after which any change to the global or per BGP neighbor inbound/
outbound policies are applied.
Whenever policies (route-maps/prefix-lists/as-path-lists) or neighbor attributes like send-community,
remove-private-asn etc. are modified by the user, the policies are scheduled to be applied after the
current delay timeout. Whenever the delay is configured by the user, the pending polic ges if any are
rescheduled with the new delay if the previous delay timeout is not expired yet. Configuring the delay with
the value of 0 seconds means, the changes are applied immediately.
For any change in the outbound policies applicable to a neighbor, the WITHDRAW packets are sent
followed by the UPDATE packets when they are applied after the delay timeout. In case of changes to
other neighbor attributes like send-community, remove-private-asn etc, the WITHDRAW packets are not
sent-instead, the new UPDATEs are sent after the delay timeout.
Use the
no
command to set to the default the delay after which any change to the global or per BGP
neighbor inbound/outbound policies are applied.
timers policy-apply delay delay
no timers policy-apply delay
Parameters
delay
The time. in seconds, after which the global or per neighbor policies are
applied. The range is 0 to 180 seconds.
Содержание 5000 Series
Страница 1: ...Draft 1 2 1 ...
Страница 141: ...5000 Series Layer 2 3 Managed Data Center Switch CLI Reference Guide 135 ...
