D-Link 5000 Series, Справочное руководство CLI

Страница: 1256 / 1263

5000 Series Layer 2/3 Managed Data Center Switch CLI Reference Guide
1250
O/S Support
Table 60: Linux BSP Log Message
Component Message Cause
Linux BSP rc=10 Second message logged at bootup, right
after Starting code.... Always logged.
Table 61: OSAPI Linux Log Messages
Component Message Cause
OSAPI Linux osapiNetLinkNeighDump: could not
open socket! – or – ipstkNdpFlush:
could not open socket! – or –
osapiNetlinkDumpOpen: unable to
bind socket! errno = XX Couldn‘t open a netlink socket. Make sure
“ARP Daemon support” (CONFIG_ARPD)
is enabled in the Linux kernel, if the
reference kernel binary is not being used.
OSAPI Linux ipstkNdpFlush: sending delete
failed Failed when telling the kernel to delete a
neighbor table entry (the message is
incorrect).
OSAPI Linux osapimRouteEntryAdd, errno XX
adding 0xYY to ZZ – or –
osapimRouteEntryDelete, errno XX
deleting 0xYY from ZZ Error adding or deleting an IPv4 route
(listed In hex as YY), on the interface with
Linux name ZZ Error code can be looked
up in errno.h.
OSAPI Linux l3intfAddRoute: Failed to Add
Route – or – l3intfDeleteRoute:
Failed to Delete Route Error adding or deleting a default gateway
in the kernel‘s routing table (the function is
really osapiRawMRouteAdd()/Delete()).
OSAPI Linux osapiNetlfConfig: ioctl on XX failed:
addr: 0xYY, err: ZZ – or –
osapiNetlPSet: ioctl on XX failed:
addr:0x%YY Failed trying to set the IP address (in hex
as YY) of the interface with Linux name XX,
and the interface does not exist.
Sometimes this is a harmless race
condition (e.g., we try to set address 0
when DHCPing on the network port (dtl0)
at bootup, before it's created using TAP).
OSAPI Linux Ping: sendto error Trouble sending an ICMP echo request
packet forthe Ul ping command. Maybe
there was no route to that network.
OSAPI Linux Failed to Create Interface Out of memory at system initialization time.
OSAPI Linux TAP Unable to open XX The/dev/tap file is missing, or, if not using
the reference kernel binary, the kernel is
missing “Universal TUN/TAP device driver
support” (CONFlG_TUN).
OSAPI Linux Tap monitor task is spinning on
select failures – then – Tap monitor
select failed: XX Trouble reading the/dev/tap device, check
the error message XX for details.
OSAPI Linux Log_lnit: log file error – creating
new log file This pertains to the “event log” persistent
file in flash. Either it did not exist, or had a
bad checksum.