Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 50 / 312

ACCELERATOR AND BRAKE PEDAL ASSEMBLIES Accelerator Pedal Adjustment
Page 5-8 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
5
Accelerator Pedal Adjustment Continued:
8. Connect the accelerator rod at the accelerator pedal (Figure 5-11, Page 5-9) .
8.1. Before tightening jam nuts on accelerator rod, press accelerator pedal and make sure the carbu-
retor throttle actuates when the cam moves approximately 8° to 12° (Figure 5-10, Page 5-8) . See
following NOTE.
NOTE: After the accelerator pedal and rod are adjusted, the final governed engine RPM should be set to:
FE400 Engine: 3850 (±30) RPM
See Engine RPM Adjustment, Section 14, Page 14-10.
8.2. Hold the ball joint at each end of the accelerator rod (17) with pliers and tighten the accelerator rod
jam nuts (18) against each ball joint (Figure 5-11, Page 5-9) .
8.3. Install the electrical box cover and screw and tighten to 18 in-lb (2 N·m).
9. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3. .
Figure 5-10 Accelerator Cable and Electrical Box
RETAINING
NUTS
TOP VIEW OF THE
ELECTRICAL
COMPONENT
BOX
CAM
PARALLEL
WITH
BOX