Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 250 / 312

FUEL SYSTEM Fuel Tank
Page 14-26 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
14
FUEL TANK STORAGE OR DISPOSAL
1. Remove the cap from the tank and thoroughly rinse it with water. The cap may be discarded or kept as
a spare.
2. Flush the fuel tank with water to remove any remaining gasoline. Use a well-ventilated area.
3. Set the tank upside down so that the water can drain. Use a well-ventilated area. Allow the tank to sit for
24 hours to dry. See following WARNING.
ý
WARNING
• Dispose of wastewater and fuel tank in accordance with federal, state and local laws and
ordinances.
4. Store the tank upside down, with the cap installed. Use a well-ventilated area.
FUEL TANK INSTALLATION
1. Turf 272/Carryall 272/XRT 1200:
1.1. Position the retaining straps (13 and 10) and install the fuel tank (Figure 14-16, Page 14-24) .
1.1.1. Position the straps in the indentions on the tank.
1.2. Install the screws (12 and 14) into the speed nuts (11) and tighten screws to 25 in-lb (2.8 N·m)
(Figure 14-16, Page 14-24) .
2. Carryall 474/XRT 1200 SE:
2.1. Position the retaining strap (13) and install the fuel tank (Figure 14-17, Page 14-25) .
2.2. Install the nut (12) onto the J-bolt (8) and tighten to 25 in-lb (2.8 N·m).
2.3. Return the seat support (1) to its original position by rotating it 90° counterclockwise
(Figure 14-14,
Page 14-22) .
2.4. Install the seat support and seat handles and tighten bolts (8) to 13 ft-lb (17.6 N·m). See Figure 4-3,
Section 4, Page 4-8.
3. Connect the vent tube (6) to the gas tank vent (Figure 14-16, Page 14-24 or Figure 14-17,
Page 14-25) .
4. Connect fuel line (1) to the fuel tank shut-off valve (15). Use a new clamp.
5. Connect the black wire from the fuel gauge to one of the fuel level sending unit screws. Connect the
orange wire to the center stud and install the flat washer, lockwasher and nut and tighten to 18 in-lb (2.0
N·m)
(Figure 14-15, Page 14-23) .
6. Slide the rubber boot over the stud.
7. Check the park brake and differential lock lever for proper adjustment and operation.
8. Add gasoline to the fuel tank.
9. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
10. Check to be sure the fuel shut-off valve on top of the gas tank is in the open (ON) position (Figure 14-20,
Page 14-28 and Figure 14-21, Page 14-28) .
11. Start the engine and allow it to idle. See following DANGER.
ý
DANGER
• The engine produces carbon monoxide, which is an odorless, deadly poison. Do not operate
the engine in an enclosed area without proper ventilation.
• After installing the fuel tank and adding gasoline, carefully check all fuel lines and
connections for leaks. Repair any leaks before using the vehicle.