Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 226 / 312

FUEL SYSTEM Carburetor
Page 14-2 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
14
MAIN JET ELEVATION/SIZE CHART
CHANGING THE MAIN JET
See General Warning, Section 1, Page 1-1.
1. Remove the carburetor (Figure 14-2, Page 14-4) .
1.1. Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position.
Chock the wheels.
1.2. Disconnect battery and spark plug wire(s). See Disconnecting The Battery on page 1-3.
1.3. Turn fuel shut-off valve on gas tank to the closed (OFF) position.
1.4. Loosen the intake air hose clamp (22) and disconnect the hose (23) at the carburetor end only
(Figure 14-2, Page 14-4) .
1.5. Remove the Z-shaped end of the governor cable (carburetor end only).
1.6. Disconnect the carburetor vent line (14).
1.7. Disconnect the fuel supply line (26) at the carburetor end only. Temporarily plug the end of the fuel
line to prevent fuel leakage.
1.8. Chock the front wheels and place a floor jack under the engine mounting plate, and raise the engine
until the front bracket snubber is fully compressed. This will allow the carburetor to pass the elec-
trical box assembly.
(Figure 14-1, Page 14-2) .
1.9. Remove the carburetor retaining nuts (19), intake pipe (17) and carburetor (12) (Figure 14-2,
Page 14-4) . See following NOTE.
NOTE: Note the orientation of the gasket (16), between the carburetor intake pipe (17) and the carburetor
body (12) so that it can be replaced in the same orientation
(Figure 14-2, Page 14-4) .
Disconnect the throttle return spring (11). Note the orientation so that it can be replaced the same.
The carburetor must be kept upright during removal.
ALTITUDE
FE400 ENGINE
MAIN JET SIZE
0-3280 ft.
(0-1000 m)
88
3280-6562 ft.
(1000-2000 m)
85
6562 ft. and over
(2000 m and over)
82
Figure 14-1 Compress Engine Snubber
LIFT
SNUBBER
SNUBBER
BRACKET