Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 45 / 312

ACCELERATOR AND BRAKE PEDAL ASSEMBLIES Brake Pedal Adjustment
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 5-3
5
BRAKE PEDAL ADJUSTMENT
See General Warning, Section 1, Page 1-1.
1. Make sure the key switch is OFF and the Forward/Reverse handle is in the NEUTRAL position. Remove
the key. Chock the wheels.
2. Remove the brake rod clevis pin (8) and bow tie locking pin (21) from the brake push rod (16) and bell
crank (11) (Figure 5-1, Page 5-2) .
3. Loosen, but do not remove, the brake stop jam nut (31) (Figure 5-4, Page 5-3) .
4. Pull the brake pedal toward the rear of the vehicle until the brake stop bumper will not allow the pedal
to travel any further (Figure 5-5, Page 5-3).
5. Holding the brake pedal in this position, measure the distance from the back of the brake pedal to the
floorboard. If it is between 6-3/8 inches (16.2 cm) and 6-7/8 inches (17.5 cm), proceed to step 7.
Figure 5-2 Jack Stand Location on I-Beam Figure 5-3 Brake Pedal Weldment Through Floor
Figure 5-4 Adjust Brake Pedal Height Figure 5-5 Measure Brake Pedal Height
Club C
ar ST
O
P
Installation
Removal
22
31
ST
OP
1 2
3
4
5
6
7
8
9
10 11
12
Correct pedal position
is 6-5/8 in. ±1/4 in.
(16.8 cm ±6 mm) from
floormat to back of
brake pedal.