Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 273 / 312

MC012C-BS00 UNITIZED TRANSAXLE WITH DIFFERENTIAL LOCK Unitized Transaxle Installation
2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual Page 16-17
16
11. Install the key onto the input shaft (Figure 16-44, Page 16-19) .
12. Position the driven clutch on the transaxle input shaft and install the washer (yellow side facing out) and
mounting bolt and tighten to 14 ft-lb (19.0 N·m) (Figure 16-44, Page 16-19) .
13. Install the drive belt. See Drive Belt Installation, Section 17, Page 17-3.
14. Remove the blocks from under the engine and roll the powertrain into position under the vehicle. Lift the
front of the powertrain and place the snubber into the snubber bracket in the vehicle frame
(Figure 16-45, Page 16-19) .
15. Position the powertrain, using the floor jack, to align the leaf springs in the front spring mounts and install
the grade eight bolts and locknuts and tighten to 15 ft-lb (20.3 N·m) (Figure 16-42, Page 16-18) . See fol-
lowing CAUTION.
ý
CAUTION
• Use only grade eight bolts for the front leaf spring supports.
16. Adjust the powertrain height, using the floor jack, to align the leaf springs for mounting in the shackles
and install the mounting bolts and locknuts and tighten to 15 ft-lb (20.3 N·m) (Figure 16-43, Page 16-18) .
17. Raise the vehicle with the floor jack and remove the jack stands. Gently lower the vehicle and finish tight-
ening the lug nuts, using a crisscross pattern, to 55 ft-lb (74.6 N·m) for steel wheels or 65 ft-lb (88 N·m)
for alloy mag wheels.
18. Position shocks in the shock mounts and install cushions, mounting washers and nuts and tighten until
cushions expand to be the same diameter as the mounting washers (Figure 16-41, Page 16-18) .
Figure 16-39 Governor Cable Bracket Figure 16-40 Governor Arm
1. Install the governor arm
on the governor shaft.
2. Turn shaft counterclockwise.
4. Tighten the
retaining nut.
3. Pull governor arm rearward.