Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 156 / 312

TROUBLESHOOTING AND ELECTRICAL SYSTEM: FE400, KEY-START ENGINE Test Procedures
Page 11-28 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
11
Ignition Coil – Bench Test
1. Remove the coil from the engine. See Ignition Coil Removal, Section 12, Page 12-34.
2. Using a multimeter set to 200 ohms, measure the primary coil resistance.
2.1. Place the black (–) probe of the meter on the terminal on the ignition coil (1), and place the red (+)
probe on the core (2) (Figure 11-32, Page 11-29) .
2.2. If the resistance is not between 0.6 - 1.7 ohms, replace the ignition coil.
3. Using a multimeter set to 20k ohms, measure the resistance of the secondary coil and spark plug cap
together.
3.1. Place the red (+) probe of the meter into the end of the spark plug cap that normally connects to
the spark plug (3) and place the black (–) probe on the core (2) (Figure 11-33, Page 11-29) .
3.2. If the resistance is between 12.0k - 14.0k ohms, the secondary coil and spark plug cap are within
acceptable limits; proceed to step 6 on page 11-30. If the resistance is not between 12.0k - 14.0k
ohms, the spark plug cap and secondary coil must be tested independently from each other.
Figure 11-31 Secondary Coil Test Without Cap
2m
20
m
200
m
2k
200
200
200 200
20
2
200
m
500
20k
200k
2000
k
1000
OFF
WAVETEK 5XL
V
V
V
A
! !
COM 200nA
MAX
1000 ---
750V
FUSED