Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 172 / 312

ELECTRICAL COMPONENTS: FE400, KEY-START ENGINE Starter/Generator (Model G425419)
Page 12-2 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
12
3. Remove the mounting/adjustment nut (12), washer (9) and bolt (11). Lower the starter/generator and slip
the belt (4) off the pulley (10).
4. Support the starter/generator so that when the pivot bolts are removed the starter/generator will not fall
to the ground. Remove the two pivot nuts (7) and bolts (5) from the mounting bracket.
5. Remove the starter/generator.
Disassembly of the Starter/Generator to Service the Brushes
1. Remove the two bolts (20) and pull commutator end cover (23) free of starter/generator housing (24)
(Figure 12-2, Page 12-2) . See following NOTE.
NOTE: Brushes must be removed to avoid damage from commutator removal. Lift the brush springs out of
the notches in the brushes and pull the brushes back from the center of the commutator end cover.
The springs will help prevent them from sliding back towards the center
(Figure 12-6, Page 12-4).
2. Remove brush covers (29 and 30), screws (25), lockwashers (26), brush springs (28) and brushes (27)
(Figure 12-3, Page 12-2) . See following NOTE.
NOTE: To clean and inspect the armature/commutator and the bearings, see Disassembly of the
Starter/Generator to Service the Armature/Commutator on page 12-3.
Brush Inspection and Replacement
1. Visually inspect brushes. Replace brushes that are cracked or severely chipped.
2. Check the wear line on the side of the brush. If the end of the brush is within 1/16-inch (1.6 mm) of the
wear line, replace all four brushes (Figure 12-4, Page 12-2).
Figure 12-2 Commutator End Cover Figure 12-3 Brush Covers and Brushes
Figure 12-4 Inspect Brushes
20
23
24
26
27
29
23
TYPICAL
3 PLACES
25
TYPICAL
4 PLACES
30
28
0
1
1/2
1/2
STARTER/GENERATOR
BRUSH
WEAR LINE
BRUSH
HOLDER