Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 180 / 312

ELECTRICAL COMPONENTS: FE400, KEY-START ENGINE Starter/Generator (Model 114-01-4005)
Page 12-10 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
12
5. Place a pry bar (13) between the top of the starter/generator mounting bracket (2) and the underside of
the starter/generator, by passing the pry bar under the exhaust header.
6. Hold the pry bar and measure the belt tension using a Krikit
®
gauge (1) (available at NAPA
®
Auto Parts
stores), or equivalent. Proper tension for a new starter/generator belt should be 75 ft-lb (101.7 N·m), or
45 ft-lb (61 N·m) for an existing belt
(Figure 12-14, Page 12-10) .
7. While maintaining the tension, tighten the adjustment nut (12) to 144 in-lb (16.3 N·m). Tighten the two
pivot bolts (5) and hex nuts (7) to 23 ft-lb (31.2 N·m) (Figure 12-13, Page 12-10). See following CAU-
TION.
ý
CAUTION
• Remove pry bar before starting engine.
8. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
STARTER/GENERATOR (MODEL 114-01-4005)
See General Warning, Section 1, Page 1-1.
Testing the Starter/Generator
See Test Procedure 8, Section 11, Page 11-19. Also See Test Procedure 11, Section 11, Page 11-22.
Starter/Generator Removal
1. Disconnect battery and spark plug wire(s). See Disconnecting The Battery on page 1-3.
2. Remove the access panel on the vehicle.
Figure 12-13 Starter/Generator Assembly Figure 12-14 Belt Tension Gauge
13
7
5
TYPICAL
2 PLACES
2
3
10
4
11
1
9
12
END VIEW
1