Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 232 / 312

FUEL SYSTEM Engine Control Linkage
Page 14-8 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
14
2. Install the Z-shaped end into carburetor throttle and push cable down into bracket (19) slot to secure. Be
sure the bellows dust shield is attached.
3. Use a 1/8-inch punch or scratch awl to turn the governor arm shaft counterclockwise until it stops. Then
pull the governor lever arm rearward until the carburetor throttle is in the “wide open throttle” (WOT) posi-
tion.
4. Hold the arm and shaft in the fully counterclockwise position and tighten the governor arm lever nut to
36 in-lb (4.0 N·m).
5. Check engine RPM adjustment. See Engine RPM Adjustment on page 14-10.
ACCELERATOR CABLE
Accelerator Cable Removal
1. Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL posi-
tion. Chock the wheels.
2. Disconnect battery and spark plug wire(s). See Disconnecting The Battery on page 1-3.
3. Remove the air intake hose from the carburetor.
4. Remove the electrical component box cover and loosen the cable housing retaining nuts (Figure 14-5,
Page 14-8) .
5. Disconnect cable from cam in the electrical component box (Figure 14-5, Page 14-8) .
6. Remove the accelerator cable (7) from the engine bracket (17) and lift the Z-shaped cable end from the
bracket (Figure 14-8, Page 14-11) .
7. Disconnect the spring (16) from the engine governor arm by rotating the arm counterclockwise one-half
turn. Remove the cable assembly from the vehicle.
Figure 14-5 Cam Position Figure 14-6 Accelerator Rod
RETAINING
NUTS
CAM
PARALLEL
WITH
BOX
PULL SPRING RELEASE
TO INSTALL
ACCELERATOR ROD
BOTTOM VIEW
3