Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 300 / 312

TORQUE CONVERTER Driven Clutch
Page 17-16 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
17
NOTE: This process is for field or remote assembly requirements where hydraulic and pneumatic press
equipment is not available. Use the Cam Installation Tool (CC P/N 101808401) for this process
(Figure 17-20, Page 17-16) .
5.2.1. With the clutch loosely assembled, set the edge of the clutch body (5) on a clean, flat sur-
face.
5.2.2. Assemble the threaded bolt (1) through the washer (2), the thrust bearing assembly 93),
the second washer (2), and the hub guide (4) (Figure 17-20, Page 17-16) .
NOTE: It is very important that the bolt, washers and thrust bearing assembly be assembled in the order
described and shown.
5.2.3. Slide the bolt (1) through the clutch body (5) until the threaded bolt, washers, bearing, and
hub guide are against the fixed face hub (Figure 17-20, Page 17-16) .
5.2.4. Hold the clutch assembly and cam installation tool together and place the fixed face down
on spaced blocks as illustrated (Figure 17-19, Page 17-16) .
5.2.5. Place the cam press hub (6) onto the cam installation bolt and thread it down onto the cam
hub, centering the press hub onto the cam hub.
5.2.6. Hold the fixed face assembly of the clutch (5) and rotate the moveable face of the clutch
one-third turn clockwise.
5.2.7. Use two wrenches, and hold the bolt head while tightening the cam press hub (6), pressing
the cam onto the keyed shaft. Advance the press hub until it is firm against the shaft end.
5.2.8. Remove the cam press hub (6) and installation tool, and install the retaining ring.
NOTE: The cam has an interference fit with the keyed shaft and should remain in position when the cam
installation tool is removed, providing for the assembly of the retaining ring.
The retaining ring can be reused provided the O.D. does not exceed 1.607 inches (40.82 mm).
Otherwise it must be replaced with a new ring (CC P/N 1014080).
5.2.9. While holding onto the cam, tap the end of the fixed face shaft lightly with a plastic mallet
until the cam seats against the retaining ring. See following CAUTION.
ý
CAUTION
• Do not use a metal hammer to tap the fixed face hub. A metal hammer will damage the shaft.
Figure 17-19 Cam Press Tool Figure 17-20 Cam Installation Tool
CAM PRESS TOOL
1
2
3
5
1
2
3
2
4
6