Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 122 / 312

PERIODIC MAINTENANCE Engine Oil
Page 10-6 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
10
ý
WARNING
• Do not attempt to change engine oil when the engine is hot or even warm. Engine oil can
cause skin burns.
• Wear safety glasses or approved eye protection when servicing the vehicle. Wear rubber
gloves when handling oil drain plug, oil filter, and oil drain pan.
6. Clean the oil drain plug threads with solvent to remove oil and oil residue. Make sure that the compres-
sion washer remains on the drain plug.
7. Use a 14 mm socket or wrench and replace the front oil drain plug, turning it clockwise, and tighten to
18 ft-lb (24.4 N·m).
8. Place a floor jack under the rear receiver hitch where the hitch and body frame are fastened. Lift the vehi-
cle body slightly, allowing the front of the engine to tilt slightly downward. This will allow the oil filter more
clearance under the electrical component box
(Figure 10-6) .
9. Relocate the oil drain pan to a position under the engine oil filter (Figure 10-7) .
10. Remove the engine oil filter, turning it counterclockwise, allowing the residual oil in the filter port and filter
to drain into the oil drain pan. See following NOTE
NOTE: An oil drip guard can be used to prevent excess oil from dripping into the engine base place. Use
an empty quart (one liter) container and cut the bottom off at an angle, then slide the open area of
the container up and under the oil filter prior to removing. Position the port of the plastic container
so oil will be directed into the oil pan
(Figure 10-7, Page 7) . A drip guard can be made by folding
a piece of cardboard, thin metal, or plastic under the oil filter forming a channel to direct the filter
port oil into the drain pan.
Dispose of used oil according to the environmental laws and regulations for your area.
Figure 10-5 Engine Oil Drain Plug and Pan
1. Drain pan 2. Drain plug 3. Oil filter
1
3
2