Club Car CARRYALL 272, Руководство по техническому обслуживанию и ремонту

Страница: 190 / 312

ELECTRICAL COMPONENTS: FE400, KEY-START ENGINE Starter/Generator (Model 114-01-4005)
Page 12-20 2006-2010 Turf/Carryall 272/472 and XRT 1200/1200 SE Maintenance and Service Manual
12
7. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
Belt Tension Adjustment
Belt tension should be checked periodically. If the belt slips when starter/generator motor operates, adjust belt
to correct tension.
1. Disconnect battery and spark plug wire(s). See Disconnecting The Battery on page 1-3.
2. Remove the access panel on the vehicle.
3. Make sure the two pivot bolts (5) on the mounting bracket are finger tight. The carriage bolt (11) and hex
nut (12) are to be finger tight also (Figure 12-27, Page 12-20) .
4. Push the starter/generator down so it is at the lowest point of its adjustment travel. With the starter/gen-
erator belt in place around the drive clutch pulley, install the starter/generator belt (3) around the pulley
(10) on the end of the starter/generator.
5. Position a pry bar (13) between the top of the starter/generator mounting bracket (2) and the underside
of the starter/generator by passing the pry bar under the exhaust header.
6. While holding the pry bar, measure the belt tension using a Krikit
®
gauge (1) (available at NAPA
®
Auto
Parts stores), or equivalent. Proper tension for a new starter/generator belt should be 120 lb (534 N) or
70 lb (311 N) for an existing belt
(Figure 12-28, Page 12-20) .
7. While maintaining the tension, tighten the adjustment nut (12) to 144 in-lb (16.3 N·m). Tighten the two
pivot bolts (5) and hex nuts (7) to 23 ft-lb (31.2 N·m) (Figure 12-27, Page 12-20) . See following CAU-
TION .
ý
CAUTION
• Remove pry bar before starting engine.
8. Connect battery and spark plug wire(s). See Connecting The Battery on page 1-3.
Figure 12-27 Starter/Generator Installation Figure 12-28 Belt Tension Gauge
1. Belt Tension Gauge 2. End View
13
7
5
2
3
10
4
11
1
9
12
1
2