Buchi DuMaster D-480, Руководство по эксплуатации

Страница: 290 / 354

Operating instructions DuMaster D-480 ©BÜCHI Labortechnik AG
10 - Menu and dialog descriptions 290
System > Wake up (Command)
What is the command used for?
This command wakes up the "sleeping" system. The carrier gas is reactivated and the furnaces are
heated back up to their working temperatures. This command is used to manually wake up the
system if you need to start up the system prematurely, i.e. earlier than the chosen wake-up time.
Short cuts
Invocation via the toolbar:
Note
If you have defined a wake-up time that is in the past, you must wake up the sleeping system again
with this command.
Feeding (Dialog)
Function
In this dialog you specify the size of the sample carousel. Make sure that the setting here matches to
the actual size of the sample carousel.
Open
Open the dialog by selecting
System > Feeding
.
Elements
The following describes the elements of the dialog.
Label Element type Meaning
Carousel with {n}
positions
Radiobutton The feeding system is switched to a carousel size of {n}
positions.
OK
Button Saves the setting.
Cancel
Button Aborts the process.
Further information
Further information includes instructions in which the dialog is used and knowledge articles
concerning the dialog:

Stopping continuous analysis
(on page 248).

Right mouse button function
(on page 67).
Adjust carousel position (Dialog)
Note
This function is only available in the solids modes.
Function
After a power failure or if you repeat initial startup and remove the carousel, it is necessary to readjust
the position of the carousel.