Buchi DuMaster D-480, Руководство по эксплуатации

Страница: 322 / 354

Operating instructions DuMaster D-480 ©BÜCHI Labortechnik AG
10 - Menu and dialog descriptions 322
Label Element type Meaning
Cancel
Button Discards settings not yet saved.
Further information
Further information includes instructions in which the dialog is used and knowledge articles
concerning the dialog:

Exporting LIMS data
(on page 158)

Defining the LIMS / PC interface
(on page 84).

Laboratory information and management system (LIMS)
(on page 70).

LIMS export settings
(on page 79).
Method (Dialog)
Function
In this dialog you can create, delete, view, copy and change methods.
Note
The method parameters can not only be defined via a method but also via the "Device parameters"
dialog. If not otherwise defined by a method, the settings in the "Device parameters" dialog apply. If a
parameter is defined differently in the method and in the "Device parameters" dialog, the method
takes priority if it is used for the measurement.
Open
Open the dialog by selecting
Options > Settings > Methods
.
Elements
The following describes the elements of the dialog.
Label Element type Meaning
--- Listbox This field lists all methods already defined.
Identifier Textbox Field to input the name of the method. When you enter the
name in the sample view, this method is allocated to the
appropriate sample.
Description Textbox Field to input the purpose of the method. For easier
selection of a method.
O2 dosing time Textbox Field to input the duration of O
2
dosing during the
combustion phase. The O2 dosing can be gradually filled in
by adjusting the O2 dosing time 1.
O2 dosing flow Textbox Field to input the duration of oxygen flow during the
combustion phase. The O2 flow can be gradually filled in
by adjusting the O2 dosing flow 1.
O2 cut off threshold Textbox Field to input a value which delimits the oxygen excess. If
during the oxygen dosing the measured oxygen
concentration exceeds this value, then the oxygen supply
will be turned off.
Autozero delay Textbox Field to input a time. Defines the time to wait after
introduction until the system performs autozero alignment.