Atlas Copco PowerMACS 4000, Руководство пользователя

Страница: 455 / 668

Peripheral Devices
9836 3521 01 455
8.11.3.2 TC Result Record Formats
The tightening results are reported to FSH according to the specification, with following additional
information.
Field Implementation
Network Id
IP address of TC.
Station Number Configurable via
ToolsTalk PowerMACS
.
Cycle Number Data Number.
Number of Spindles Reports number of bolts in the cycle data.
Parameter Set Mode number
Supplier Code
"ACS".
Vehicle ID code. (PVI No) ID device string converted to a number.
Spindle Ordinal bolt number within the station.
Torque Bolt Torque from the Monitor function.
Torque Low Limit Bolt Torque, Min limit, from the Monitor function.
Torque High Limit Bolt Torque, Max limit, from the Monitor function.
Angle Bolt Angle from the Monitor function.
Angle Low Limit Bolt Angle, Min limit, from the Monitor function.
Angle High Limit Bolt Angle, Max limit, from the Monitor function.
Status Bits Completion, Torque Status, Torque Spec, Angle Status, and Angle Spec
are set in accordance to the corresponding bits in the Bolt level result
variables
"
Compact Errors"
.
The Time Status and Time Spec bits are set according to the status of the
bits TIR, TIL, TIH in the Bolt level result variables
"
Errors
". The following
rules are used::

If neither TIR, TIL nor TIH are set then Time Status and Time
Spec are set to 0.

If at least one of TIR, TIL or TIH is set then Time Status is set to 1.
If TIL is set then Time Spec is set to 0 (regardless if TIR and/or TIH
are set as well). If only TIR and/or TIH are set then Time Spec is set to
1.
Tool Serial Number The value of the
Spindle Set Up
/
General
parameter "Spindle Serial
Number" for the spindle that was used to tighten the bolt in
question.