ZyXEL Communications MSC1000G Series, User Manual

Page: 108 / 1168

Chapter 4 Access Control List Screens
Management Switch Card User’s Guide
108
EAPOL Filter
Out EAP (Extensible Authentication Protocol, RFC 2486) over LAN. EAP is used with IEEE 802.1x
to allow additional authentication methods (besides RADIUS) to be deployed with no
changes to the access point or the wireless clients.
IGMP Filter Out Internet Group Management Protocol is used when sending packets to a specific group of
hosts.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
Copy Do the following to copy the settings you configure above to another port or ports.
1. Click Copy .
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
ID This is the slot number of a line card. Click the index number of an active line card to display
the
Packet Filter Slot screen where you can view and copy settings from one port to
another port or ports on the selected line card.
State This field displays the line card’s current operational status.
active means the line card is operating normally.
init means the MSC is initializing the line card.
disable means a manager has disabled the line card.
inactive means the line card is starting up or is not operating normally. This could be due to
the card starting, a firmware upgrade in progress or a malfunction. See Section 38.7 on page
1111 for what to do if the line card stays stuck in the inactive state.
Card Type This field displays the type of a line card.
Up Time This field displays how long the line card has been running since the last time it was started.
Firmware This field displays the current firmware version installed on the line card.
Table 29
Packet Filter (continued)
LABEL DESCRIPTION