ZyXEL Communications MSC1000G Series, User Manual

Page: 1027 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
1027
33.14.11 switch port pvid Command
Syntax:
switch port pvid < giga-port > < vid >
where
This command sets the Port VLAN ID assigned to untagged frames or priority frames (0 VID)
received on this port(s).
The following example sets the PVID of uplink interface 1 to 76.
33.14.12 switch port show Command
Syntax:
switch port show
This command displays the settings for the system’s Gigabit Ethernet interfaces. An example is
shown next.
33.14.13 switch port speed Command
Syntax:
switch port speed <giga-port> <speed>
where
< pvid >
=
The default Port VLAN ID (PVID) assigned to untagged frames or priority-tagged
frames received on this port. 1~4094.
ras> switch port pvid up1 76
ras> switch port show
port name en mode speed fc pvid prio gvrp ftype vt dscp
----- --------------- ---- ---- ------ ---- ---- ---- ---- ----- ---- ----
sub1 Subtend1 V up auto - 1 0 - all - -
sub2 Subtend2 V up auto - 1 0 - all - -
up1 Uplink1 V up auto - 1 0 - all - -
up2 Uplink2 V up auto - 1 0 - all - -
< giga-port >
=
This represents 1000BaseT uplink ports. The port speed is fixed for subtending
ports and/or SFP slots that use a fiber-optic interface. Specify an individual
interface if trunking is not enabled. Use
tup|all
if trunking is enabled.
< speed >
= The port’s speed and duplex mode.
Use
auto|1000F|100F|100H
.
Auto or 1000 (Mbps) or 100 (Mbps) is to match the port speed of the WAN switch
to which this port is to connect.
F is for full duplex communications or H for half duplex communications.