ZyXEL Communications MSC1000G Series, User Manual

Page: 1073 / 1168

Chapter 36 voip Commands
Management Switch Card User’s Guide
1073
36.4 voip h248 Commands
Use these commands to manage the VoIP line cards.
36.4.1 voip h248 interface bhca command
Syntax :
voip h248 interface bhca <id> <peak> <average>
where
Use this command to set the maximum number of Busy Hour Call Attempts (BHCA) allowed per
second (peak) and per hour (average).
The following example configures H.248 interface 1 to allow up to 20 call attempts per second and
10,000 call attempts per hour.
36.4.2 voip h248 interface group command
Syntax :
voip h248 interface group <id> <primary> <secondary>
where
Use this command to set the slot numbers of the interface’s active and backup signaling cards.
The following example configures H.248 interface 1 to use a VOP in slot 3 as the primary (active)
signaling card and a VOP in slot 6 as the secondary (backup) signaling card.
36.4.3 voip h248 interface ip command
Syntax :
voip h248 interface ip <id> < ip-address >[/<mask>] <vid>
Use this command to set the H.248 interface’s IP address, subnet mask, and VLAN ID. The active
signaling card uses this IP address to communicate with the Media Gateway Controllers (MGC).
peak
The maximum number of call attempts per second (0~30).
average
The maximum number of call attempts for an hour (0~60000).
ras> voip h248 interface bhca 1 20 10000
primary
The number of the slot containing the active signaling card.
secondary
The number of the slot containing the backup signaling card.
ras> voip h248 interface group 1 3 6