ZyXEL Communications MSC1000G Series, User Manual

Page: 683 / 1168

Management Switch Card User’s Guide
683
C
H A P T E R
2 0
alarm Commands
This chapter describes the alarm management commands.
20.1 General alarm Command Parameters
The following table describes commonly used
alarm
command parameter notation.
20.2 alarm Commands Summary
The following table lists the
alarm
commands. The P column on the right indicates the
administrator privilege level needed to use the command.
Table 348
General alarm Command Parameters
NOTATION DESCRIPTION
alarm
Specify a category of alarms.
eqpt
represents equipment alarms.
dsl
represents Digital Subscriber Line (DSL) alarms.
enet
represents Ethernet alarms.
sys
represents system alarms.
all
specifies every alarm category.
severity
Specify an alarm severity level (
critical
,
major
,
minor
,
info
or
all
).
condition
Specify an alarm condition.
condition
|
code
|
all
sdate
Specify a start date in yyyy/mm/dd format.
edate
Specify an end date in yyyy/mm/dd format.
target
snmp|syslog|all|none
‘none’ disables alarm reports on this alarm category.
for|rev
Specify the displaying order.
for
= forward,
rev
= reverse
detail
Display more comprehensive alarm condition descriptions.
fac
This is an alarm category. Options are:
local1~local7
Table 349
alarm Commands
COMMAND DESCRIPTION P
alarm clear
Erases historic alarm entries. 8
cutoff
Cancels an alarm. This stops the sending of the
alarm signal current. 8