ZyXEL Communications MSC1000G Series, User Manual

Page: 809 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
809
This command creates a PPPoA-to-PPPoE PVC to allow communication between the ATM (CPE) and
Ethernet network (BRAS) segments. The PVC is mapped to a PPPoE session that connects to the
specified BRAS.
The following example creates a PPPoA-to-PPPoE PVC (
1/33
) for port
1
on the line card in slot
3
.
The PVC uses
llc
encapsulation and the
DEFVAL
ATM profile with a priority of
1
. This configuration
is for the
video
service on the
vom
access concentrator. The switch waits until the
hello time
timeout before terminating the PPPoE session.
29.24.3 port paepvc show Command
Syntax:
port paepvc show < slot >|< slot-port >|< slot-port-vpi/vci >
This command displays the PPPoA-to-PPPoE PVC settings for the specified port and/or slot.
The following example displays the settings on the line card in slot 3.
29.25 port pots cid set Command
Syntax:
port pots cid set <slot-port> <AS-type> <payload-type>
where
This command sets the AS type and payload type of CID (Caller Identification).
ras> port paepvc set 3-1-1/33 DEFVAL llc 2 1 acname vom srvcname video hellotime 10
ras> port paepvc show 3
pvc type mux pvid pri htime profile/acname/srvcname
-------------- ------- ----- ------ ---- ----- --------------------------
3-1-1/33 pae llc 2 1 10 DEFVAL/test/example
ras>
<
AS-type
>
=
This sets the the AS type of CID, 0~5
0: DEFVAL (use the setting of country code)
1: CID during ring
2: DTAS CID before ring
3: RPAS CID before ring
4: LR DTAS CID before ring
5: LR CID before ring
<
payload-
type
>
=
This sets the payload type of CID, 0~8
0: DEFVAL (use the setting of country code)
1: MDMF
2: SDMF
3: ETSI MDMF
4: ETSI SDMF
5: DTMF
6: UK MDMF
7: UK SDMF
8: Japanese MDMF