ZyXEL Communications MSC1000G Series, User Manual

Page: 594 / 1168

Chapter 15 VLAN Screens
Management Switch Card User’s Guide
594
2
The MSC checks the PVID table and assigns a temporary VID.
3
The MSC ignores the port from which the frame came, because the MSC does not send a frame to
the port from which it came. The MSC also does not forward frames to “forbidden” ports.
4
If after looking at the SVLAN, the MSC does not have any ports to which it will send the frame, it
won’t check the port filter.
15.6 VLAN Setup Screen
Click VLAN > VLAN in the navigation panel to display the screen shown next. You can assign the
management switch card’s Gigabit Ethernet interfaces to be members of a VLAN group or prohibit
an interface from joining a VLAN group in this screen. This is an IEEE 802.1Q VLAN.
Figure 402
VLAN Setup
The following table describes the labels in this screen.
Table 321
VLAN Setup
LABEL DESCRIPTION
Enable Select this check box to turn on the VLAN group. You cannot disable a VLAN if any PVIDs are
set to use the VLAN or the VLAN is the CPU (management) VLAN.
Name Enter a descriptive name for this VLAN group for identification purposes.
VID Enter the VLAN ID (VLAN Identifier) for this static VLAN entry; the valid range is between 1
and 4094.
Port This is the label of a Gigabit Ethernet interface.