ZyXEL Communications MSC1000G Series, User Manual

Page: 104 / 1168

Chapter 4 Access Control List Screens
Management Switch Card User’s Guide
104
The following table describes the labels in this screen.
Table 27
OUI Filter
LABEL DESCRIPTION
Slot
Port
Use the drop-down list boxes to select a DSL port or Gigabit Ethernet port on a line card for
which you wish to configure packet type filtering.
Load Click Load to display the port’s current settings.
Enable Select Enable to activate this filter.
Clear this check box to disable the filter without deleting it.
Mode Specify the action on matched frames.
Select accept to allow frames with a matched OUI field in the MAC addresses. The switch
blocks frames with other OUIs not specified.
Select deny to block frames with a matched OUI field in the MAC addresses. The switch
allows frames with other OUIs not specified.
OUI1.. 10 Enter the first three octets of a MAC address in the format xx:xx:xx. For example, 00:0F:FE.
Apply Click Apply to save the changes in this screen to the system’s volatile memory. The system
loses these changes if it is turned off or loses power, so use the Config Save link on the
navigation panel and then the Save button to save your changes to the non-volatile memory
when you are done configuring.
Cancel Click Cancel to begin configuring the screen again.
Copy Do the following to copy the settings you configure above to another port or ports.
1. Click Copy .
2. Select to which line card you want to copy the settings.
3. Select to which ports on the line card you want to copy the settings. Use Select All to
select every port. Use Select None to clear all of the check boxes.
4. Click Apply to paste the settings.
ID This is the slot number of a line card. Click the index number of an active line card to display
the
OUI Filter Slot screen where you can view and copy settings from one port to another
port or ports on the selected line card.