ZyXEL Communications MSC1000G Series, User Manual

Page: 542 / 1168

Chapter 13 Switch Screens
Management Switch Card User’s Guide
542
Figure 374
CFM Endpoint: MEP
The following table describes the labels in this screen.
Table 288
CFM Endpoint: MEP
LABEL DESCRIPTION
MD Name This displays the name of the MD for which you want to configure end points.
MA Name This displays the name of the MA for which you want to configure end points.
Endpoint ID Select a valid MEP ID which is defined in the CFM maintenance association screen.
Port This binds the MEP ID to a physical port on the device. You can select an Ethernet port
(
enet1 or enet2 ) or select a DSL port (by specifying a slot number and port number of a
line card).
Direction Select whether to send CCMs (Connectivity Check Messages) from the end point you
selected in this screen (when you select
down ) or from (s) (when you select up ). Select
up only when the link of the specified end point is down.
Priority Select the priority level for the CCMs configured in this screen. "0" is the lowest priority
level and "7" is the highest.
CCI-enabled Select this to enable CCMs sending from the end point configured in this screen. Deselect
this to stop CCMs sending.
Alarm Time This is the number of seconds the MSC waits to send a local alarm after three
CFM_ERROR events have been detected.
Reset Time This is the number of seconds the MSC waits to cancel a local alarm after a CFM_ERROR
event has been resolved and no other alarms that have occurred.
MAC Address Enter the CFM end point’s MAC address.
Apply Click Apply to add the settings as a new entry in the summary table above.
New Click New to start configuring an MA setting.
Cancel Click Cancel to reset the fields.
Index This field displays the index number of an end point.
MEP ID This field displays the MEP ID of the end point used when you need to do a CFM test or
view the CFM statistics.