ZyXEL Communications MSC1000G Series, User Manual

Page: 812 / 1168

Chapter 29 port Commands
Management Switch Card User’s Guide
812
29.28.4 port ppvc set Command
Syntax:
port ppvc set < slot-port-vpi/vci > < mux > < pvid > < priority >
where
This command creates a PPVC.
The following example creates a PPVC with VPI 8 and VCI 35 for port 5 on the line card in slot 7.
The PPVC uses llc encapsulation and default VID 25. Any frames received without an IEEE 802.1p
priority tag will be assigned a priority of 3.
29.28.5 port ppvc show Command
Syntax:
port ppvc show < slot >|< slot-port >|<s lot-port-vpi/vci > [detail]
where
This command displays the runtime configured PPVCs.
< slot-port-
vpi/vci >
=
The slot, port(s) and VPI/VCI of the PPVC.
< mux >
= The type of encapsulation:
llc
,
vcmux
< pvid >
= Set a default VID (1 to 4094) for the channel. The channel can only forward
frames with this VLAN ID. The system would drop any frames received from the
subscriber that are tagged with another VLAN ID.
Each PVC must have a unique VID since the system forwards traffic back to the
subscribers based on the VLAN ID.
< priority >
= Set an IEEE 802.1p default priority (0 to 7) to add to incoming frames without a
(IEEE 802.1p) priority tag.
ras> port ppvc set 7-5-8/35 llc 25 3
< slot-port-
vpi/vci >
=
The slot and port(s) and VPI/VCI of the PPVC.
< vid >
= The VLAN ID. Valid parameter range = [1 – 4094].
This must be the VLAN ID of a VLAN that is already configured. The ports
specified in this command must also be set to the fixed status in the VLAN.
[detail]
= Display the PPVC’s VLAN configuration in addition to the other PPVC settings.