ZyXEL Communications MSC1000G Series, User Manual

Page: 997 / 1168

Chapter 33 switch Commands
Management Switch Card User’s Guide
997
33.5.3.12 switch cfm md delete
Syntax:
switch cfm md delete < md-name >
This command deletes a maintenance domain.
33.5.3.13 switch cfm md set
Syntax:
switch cfm md set < md-name > < level >
This command sets a maintenance domain and it’s level. The following example configures the
maintenance domain “md1” with a level of 2.
33.5.3.14 switch cfm mep delete
Syntax:
switch cfm delete < md-name > < ma-name > < mep-id >
This command deletes an endpoint in the maintenance association. The following shows an
example.
33.5.3.15 switch cfm mep set
Syntax:
switch cfm mep set < md-name > < ma-name > < mep-id > < giga-port >|< slot-port > < direction >
< priority > [cci < cci-enabled >] [alm < alarm-time >] [rst < reset-time >] [mac < mac >]
where
re
ras> switch cfm md set md1 2
ras> switch cfm md delete
< mep-id >
= The maintenance end point identifier.
< direction >
= Choose
up|down
.
Specify whether to send CCMs (Connectivity Check Messages) from the
specified end point (
down
) or from (
up
). Select
up
only when the link of the
specified end point is down.
<priority>
=
Specifies the priority of the CCMs sent from this CFM end point.
<cci-enabled>
= Indicates whether to issue CCM or not (default is 0).
0: disabled
1: enabled
<alarm-time>
=
This is the number of seconds (2.5~10) the system waits to send a local alarm
after three times of CFM_ERROR detected. The default is 2.5 seconds.