8
IM CW240E
WARNING
●
Use of Clamp-on Current Probes
•When using clamp-on current probes, keep the circuit voltage below oper-
ating circuit voltage in order to avoid possible shorts or accidents resulting
in an injury or death.
•Ensure that the rated current of the circuit you measure matches the rating
of the current probe.
•Avoid using the instrument if it has been exposed to rain or moisture, or if
your hands are wet.
•Do not use clamp-on current probes with any non-insulated conductors.
●
Handling of Power Cord
•Use only the cord supplied from Yokogawa M&C to prevent electric shocks
and fire.
•Do not place any load on the power cord or allow the power cord to come
into accidental contact with any heat source. When unplugging the power
cord from the outlet, hold its plug, rather than holding and pulling the cord
itself.
•If the power cord is damaged, contact the vendor from which you purchased
the instrument.
●
Measures in Case of Anomalies
If the instrument begins to emit smoke, becomes too hot, or gives off an
unusual smell, immediately turn it off and disconnect the power cord from
the outlet. Also turn off power to the object under measurement that is
connected to the instrument’s input terminals. Never attempt to use the
instrument again. If any such anomalies as noted above occurs, contact
the vendor from which you purchased the instrument. Do not attempt to
repair the instrument yourself, as doing so is extremely dangerous.
Precautions for Safe Use of the Instrument