Wavetronix Click 100, User Manual

Page: 213 / 260

212
CHAPTER 24
• CLICK 304
Device ID
Gives the ID number of the device being configured, which is used
to identify the device when you are connecting to it. By default, this
number is the last five digits of the serial number, which can be found
under the About tab or on the barcode sticker on the bottom of the
device. It is recommended that you do not change this number unless
another device in the network has the same ID number.
Baud Rate
Allows you to change the baud rate at which the device connects to
the sensor.
Table 24.2 – SmartSensor Driver Setup Tab
The
About
tab contains the following information about your Click 304 (see Figure 24.5
and Table 24.3):
Figure 24.5 – SmartSensor Driver About Tab
Settings Description
Driver
Names the driver you are currently working with.
Serial Number
Displays the serial number of your device.
Firmware Version
Shows the version of firmware your device currently has installed. If
Click Supervisor detects a discrepancy between this version and the
most current version it currently has access to, you will be prompted
to upgrade when you connect to the device.
Table 24.3 – SmartSensor Driver About Tab
Under the
Diagnostics
tab, you can run diagnostics on your device (see Figure 24.6). Click
the
General
button to run diagnostics on the items listed below the button. If a problem is
detected, the program will display a red square next to the item in question. If no problems
are detected, a green circle will appear.