Wavetronix Click 100, User Manual

Page: 185 / 260

184
CHAPTER 22
• CLICK 250
Physical Features
Figure 22.2 – Diagram of the Click 250
The Click 250 is a bulkhead N-Female to N-Female connector; both connector ports are
equally protected. The ground lug and terminal are located directly on the housing of the
Click 250.
Installation
The Click 250 should be mounted in the wall (usually the bottom) of a cabinet, in a 5/8” hole.
Wavetronix fiberglass cabinets come with such holes predrilled; aluminum cabinets do not
and a hole will need to be drilled. It is recommended that the hole be in the bottom of the
cabinet, on the far right.
x
GND
Click! 250
Figure 22.3 – Click 250 in Wall of Cabinet
Follow the steps below to install a Click 250.
1
Connect a 12 AWG stranded copper grounding wire to the surge GND bolt, as shown
below. There are two bolts on the Click 250; use the bolt with the rounded top.