Wavetronix Click 100, User Manual

Page: 222 / 260

CHAPTER 26
• CLICK 330/331 221
Status Meaning
On Supply voltage is in an acceptable range
Off Supply voltage is too low
Table 25.1 – Power Monitor LEDs
˽ Each Ethernet port has two LEDs that show the data transmission speed of that port,
as shown in Table 25.2. These LEDs are labeled 100/ACT and 1000/ACT. If the LED
is on, there is an electrical link. If the LED blinks, there is currently network traffic at
that speed.
LED 10 Mbps 100 Mbps 1000 Mbps
100/ACT On or blinking On or blinking Off
1000/ACT On or blinking Off On or blinking
Table 25.2 – Ethernet Port Monitor LEDs
˽ The fiber ports on the Click 331 each have an LED labeled 1000 LNK/ACT. If this LED
is on, there is a valid connection through that port. If the LED blinks, there is currently
network traffic at 1000 Mbps.
Installation
Unlike many other Click devices, the Click 330/331 do not mount over the T-bus, meaning
that power and communications will have to be wired in.
Wiring Power and Communication
The first four screw terminals, marked US1, GND, US2 and GND, are for wiring in power.
The other two, which are labeled R1 and R2, are for security and functionality alarm pur-
poses (see Figure 25.3).
Figure 25.3 – Wiring the Click 330/331