![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677170.webp)
D292144.9.fm
Sensor Adjustments
Chapter 6: Troubleshooting
6-21
Adjusting the Tape Jam Sensor
The
Tape Jam Sensor
is one of five sensor options
that are included with the standard TM-500. It is
located on the
Taper
track just before the Sealer. It
detects if parts are doubled up or incorrectly placed in
a carrier tape pocket so that the part protrudes above
the level of the track and would interfere with cover
tape placement.
The
Tape Jam Sensor
should be enabled if the
Taper
Output Module
is being used.
If sensor sensitivity needs to be fine tuned, adjust the
amplifiers at the base of the
Cover Tape Arm
. For
more information on the sensor/amplifier, refer to
Appendix A: Sensors.
No further setup is required. The
Jam In Tape Sensor
is ready to operate.
Adjusting the Carrier Tape Low Sensor
The
Carrier Tape Low Sensor
is one of five sensors
that are included with the standard TM-500. It is
located on the
Carrier Tape Arm
. It alerts the opera-
tor at the beginning of a job if there is not enough
carrier tape loaded on the
Carrier Tape Reel
to com-
plete the job.
The
Carrier Tape Low Sensor
should be enabled if
the
Taper Output Module
is being used.
Summary of Contents for TM-500
