4-24
TM-500 User’s Guide
Taper Setup
D292144.7.fm
Note:
Excessive roller pressure may cause carrier tape advance problems or
elongation of sprocket holes in the carrier tape.
4.
After the initial adjustment, run the tape out again and observe whether the cover
tape aligns itself satisfactorily. If it is still misaligned, continue adjusting the cover
tape guide until it is aligned properly.
5.
Once the cover tape and sealer are aligned with the carrier tape, perform a pull
test as required. If the test is unacceptable, the seal strength can be adjusted.
Note:
See
Chapter 7: Troubleshooting
for sealer adjustment tips.
6.
Once the seal is satisfactory, run out the tape with
the
Continuous Advance
button until it can be
attached to the reel. The tape normally can be
attached by inserting it into the reel hub or with
adhesive tape. If a trailer is desired, continue to run out the sealed tape using
Continuous Advance
until the desired trailer length is created.
Step 5:
Setup
Output
PSA
SEALER
Summary of Contents for TM-500
