![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677104.webp)
D292144.7.fm
Taper Setup
Chapter 4: Machine Setup
4- 21
4.
Open the HMI
Taper Setup Screen
. Ensure
Tape Settings
and
Sealer Settings
are
appropriate for the current job. Engage
Automatic
Cutter
if desired.
5.
Press the
Continuous Advance
button in the
Leader
section of the
Taper
tab.
The taping module will begin the advance of the carrier tape and cover tape
through the sealer. The cover tape will be sealed onto the carrier tape as it
advances.
6.
Observe whether the sealer’s width is adjusted correctly for the cover tape. It
should seal just inside the outside edges of the carrier tape without going off the
edges or over the pockets. If it is not, stop the taper by pressing the
Continuous
Advance
button again.
The sealer’s inside and outside
seals are independently adjustable.
If one of the seals needs to be
moved, loosen the corresponding
position lock and turn the adjusters.
Turning the wheel counter-clockwise
will move the guide towards the
operator. Turning it clockwise will
move the guide closer to the
machine. Adjust the
Inner Seal
Adjust
and the
Outer Seal Adjust
to
the desired position, then tighten the
Position Locks
to secure them.
Step 5:
Setup
Output
HEAT
SEALER
Inner Seal Adjust
Outer Seal Adjust
Position Locks
Summary of Contents for TM-500
