D292144.8.fm
Preparing to Run a Pre-programmed Job
Chapter 5: Operation
5- 9
Setup 2D Vision
Note:
In order to use the Keyence IV Vision System, the camera must be configured and
set to
Run Mode
in the Keyence HMI as well as being enabled on the TM-500 HMI.
Please complete the following instructions to correctly configure the vision system.
1.
Select the
2D Tape Tab
from the
Tab Menu
.
2.
Under
Vision Settings
, turn
In-Tape Inspection
ON
( I )
. Ensure the
Pockets to Inspect
field is correct.
3.
To select a stored inspection or configure a new inspection, open the
Keyence
Inspection System
software by double-clicking on the
IV Navigator
icon on the
desktop. Then select
Network Connection
.
Step 7:
Setup
Vision
Summary of Contents for TM-500
