5-12
TM-500 User’s Guide
Preparing to Run a Pre-programmed Job
D292144.8.fm
Note:
For further instructions on Vision System use, see
Chapter 4: Setup
or the
Keyence User’s Guide
which is provided with the 2D Vision Module.
10.
Leave the
IV Navigator
program in
Run Mode
and press
Alt + Tab
to toggle back
to the TM-500 HMI. Open the
Run Tab.
Enter
Job Quantity
and
Job Name.
Press
Run
to begin operation.
Since the TM-500 automatically inspects for the last job that was run, when the first
part in the new job will trigger an
Inspection Fail
.
Summary of Contents for TM-500
