![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677138.webp)
D292144.8.fm
Preparing to Run a Pre-programmed Job
Chapter 5: Operation
5- 5
3
.
Setup the
Taper
.
• If placing to the
Taper Mod-
ule
, load the correct carrier
tape and cover tape, adjust-
ing the track width as nec-
essary.
• Select
PSA
or
Heat
seal.
• Align cover tape and sealer
with carrier tape.
• Run a pull test and adjust
seal strength as needed.
• Place an empty reel onto
the take-up reel spindle.
• Use the
Continuous Advance
button on the
Taper Tab
to run out the tape until
it can be attached to the reel. The tape normally can be attached by inserting it
into the reel hub or with adhesive tape.
Caution!
Operators should use caution when working in front of the TM-500. Be
aware of the
Takeup
Arm
and
Carrier Arm
positions to avoid tripping.
Step 1:
Setup
OUTPUT
Summary of Contents for TM-500
