![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677012.webp)
Safety Features
D292144.2.fm
ix
Safety Features
Main Power Switch
The
Main Power Switch
is located on the right side of the machine below the
polycarbonate enclosure. Turning the switch to the right turns power
ON
.
Turning the switch back to the left turns the power
OFF
.
When the
Main Switch
is in the
OFF
position, it exposes a lockout-tagout
hole. The switch can be locked by inserting a lock through the hole.
The switch on the right is pictured in the
OFF
position.
Emergency Stop Switches
There are three
Emergency Stop Switches
on the TM-500. One is located on
the front of the machine under the upper enclosure. Two more are located on
the back of the machine under the upper enclosure. When an
Emergency
Stop Switch
is triggered, all motion will be halted and the machine will require
a reset before operation can continue.
The emergency stop control circuit removes electrical power to all motors,
moving parts, heat sources, pneumatics and energy storing devices. This
includes the stepper motor drive, stepper motors, the servo motor drive,
servo motors, drive circuits, the main control board, the heat sealer and all
pneumatics. The only devices that remain powered are the inspection mod-
ule cameras, the enclosure lights, the sensors and the HMI.
Control Buttons
The TM-500
Control Buttons
are located on the front
of the machine in the top, right corner and on the right
side of the machine in the top left corner. They include
the
Reset
button, the
Stop
button and the
Start
but-
ton.
When the machine is powered up, it is automatically placed into an emergency stop state to pre-
vent the motors from moving until the operator is ready to begin operating the machine. The error
state is cleared by pressing the
Reset
button on the front of the machine.
Once a job has been selected or programmed, it can be started and stopped from the HMI or by
pressing the
Start
and
Stop
buttons.
Summary of Contents for TM-500
