D292144.8.fm
Preparing to Run a Pre-programmed Job
Chapter 5: Operation
5- 11
6.
Click
Trigger ON
, then center a part under the camera.
7.
Select or create a program from the
Program
drop-down menu. A yellow
Selection
Box
will appear over the part image.
8.
Select
Run
Mode. Click the
Manual Trigger
button which is located under the
Program
button to test the inspection criteria.
9.
The test results will appear on the right side of the window.
.
Summary of Contents for TM-500
