![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677105.webp)
4-22
TM-500 User’s Guide
Taper Setup
D292144.7.fm
7.
After the initial adjustment, run the tape out again and observe whether the cover
tape aligns itself satisfactorily. If it is still misaligned, continue adjusting the cover
tape guide until it is aligned properly.
8.
Once the cover tape and sealer are aligned with the carrier tape, perform a pull
test as required. If the test is unacceptable, the seal strength can be adjusted.
Note:
See
Chapter 7: Troubleshooting
for sealer adjustment tips.
9.
Once the seal is satisfactory, run out the tape with the
Continuous Advance
button until it can be attached to the reel. The tape normally can be attached by
inserting it into the reel hub or with adhesive tape. If a
Trailer
is desired, continue
to run out the sealed tape using
Continuous Advance
until the desired trailer
length is created.
Skip the
PSA Sealer Setup
procedure and proceed to
Leader/Trailer Settings
.
Step 5:
Setup
Output
HEAT
SEALER
Summary of Contents for TM-500
