![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677129.webp)
4-46
TM-500 User’s Guide
Setup the Pick Head
D292144.7.fm
7.
Observe the vacuum sensor indicator which is located
on the
Pick & Place Head
above the nozzles The
numbers should be lit in
green
with components on
the nozzle and
red
if components are not. If the
sensors require adjustment, increase or decrease the
test levels with the up and down buttons. Adjust them
as needed with components both on and off of the
nozzles..
Note:
See
Chapter 7: Troubleshooting
or
Appendix
A: Sensors
for tips on adjusting the
Nozzle Vacuum
Sensor
.
8.
Open the enclosure doors and manually move the pick head to the place location
(
Taper
or
Tray
). Center the nozzle over the pocket, then lower it until it is even with
the top of the pocket.
9
.
Once the nozzle is in the correct position, press the
Teach Place Positions
button.
10.
If the part needs to be rotated before it is placed
in tape, select the correct
Rotation Angle
from
the
Rotation Settings
section. The options are
0, 90, 180 and -90 degrees.
•
0
indicates no rotation is required
•
90
is a 90 degree clockwise rotation
•
180
rotates the part so it is facing in the oppo-
site direction
•
-90
is a 90 degree counterclockwise rotation
Note:
See
Chapter 7: Troubleshooting
for tips
on adjusting nozzle placement.
11.
Close the enclosure doors and press
Place Part
. Adjust the
Place Position
as
needed. The
Pick, Inspect
and
Place
positions are now set.
Note:
Manually placed parts will be counted in the current job.
Step 8:
Setup
Pick Head
Summary of Contents for TM-500
