![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677151.webp)
6-2
TM-500 User’s Guide
Emergency Stop
D292144.9.fm
Emergency Stop
If the
Emergency Stop
button is pushed, the TM-
500 will automatically enter an
Emergency Stop
state.
There are four E-Stop buttons on the TM-500.
Two are located on the front of the machine and
two are located on the back of the machine.
When an
Emergency Stop
is triggered, a brief
alarm sounds, the
Tower Light
switches to red
and all operations cease. On the HMI, an
E-Stop
status message will appear.
Activating an Emergency Stop
If a malfunction occurs, follow the steps below to resolve the failure.
1.
Press the red
E-Stop
button to place the TM-500 into an
Emergency
Stop
state. A brief alarm will sound, the
Tower Light
will switch to flash-
ing red and all operations will cease. On the HMI, an
E-Stop
status
message will appear.
2.
Resolve the problem.(See
Chapter 7: Troubleshooting
for tips on resolving error conditions.)
Clearing an Emergency Stop
To clear an
Emergency Stop
, follow the directions below.
1.
Twist the activated
Emergency Stop
button to turn it off and reset the button.
2.
Close all the doors on the TM-500.
3.
Press the blue
Reset
button.
4.
Press the green
Start
button on the machine or
press the
Run
button on the HMI
Run Tab
to
resume operation.
Front Side
E-Stop
Summary of Contents for TM-500
