5-2
TM-500 User’s Guide
Quick Start: Running a Job
D292144.8.fm
Quick Start: Running a Job
The following is an outline of the basic steps required to run a pre-programmed job. More
detailed instructions follow in the next section of this chapter.
Caution:
Users should always wear protective eye wear when operat-
ing or maintaining the TM-500.
1.
Setup Input and Output modules.
• Ensure the correct input, output and test modules are installed. Follow the setup
instructions in
Chapter 4: Machine Setup
if configuration of a newly installed
module is required.
• Load components into the
Input Module
and empty tape/trays into the
Output
Module
.
2.
Power up.
• Power up the machine. Press
Reset
. Close all doors.
3.
Activate the HMI.
• Double-click the
TM-500
HMI icon on the monitor.
4.
Home the motors.
• Open the
System Menu
and select
Home Motors
.
5.
Select Job.
• On the HMI, select the
Job Tab.
Go to the
File Menu
and select
Open
, then
select the correct job.
• Reset
Job Statistics
.
Quick
Start
Summary of Contents for TM-500
