![background image](http://html2.mh-extra.com/html/v-tek/tm-500/tm-500_user-manual_3085677196.webp)
Watlow EZ-Zone PM Express Temperature ControllerD291511.18a.fm
A-9
Appendix A: Sensors
Adjusting the Set Points
To adjust the set point, simply press the up and down arrows. The
Set Point Display
will show the
changes and the controller will immediately begin adjusting the temperature of the sealer shoes
according to the new range that results. If a large adjustment is required, pressing and holding
the up or down arrow keys will increase or decrease the set point quickly..
Default Factory Settings
Refer to the
Watlow EZ-Zone PM Express Temperature Controller
when necessary for more
detailed technical information regarding the operation of the temperature controllers. The direc-
tions below describe the factory settings set at the time the controllers are installed at V-TEK, Inc.
Initial Settings
1.
Press and hold the
Up
and
Down Arrow Keys
for about 3 seconds to enter the
Setup
Menu
.
2.
Press the green
Advance
button to scroll through the menu.
3.
Begin with the
Lockout Menu
(
LoC
). Use the arrow keys to select option
5
. Then press
the green
Advance
button to move to the next setting.
4.
In the
Sensor Type Menu
(
SEn
) select
Thermocouple
(
tC
). Press
Advance
.
5.
In the
Linearization Menu
(
Lin
) select
J
. Press
Advance
.
6.
In the
Decimal Menu
(
dEC
) select
Whole
(
0
). Press
Advance
.
7.
In the
Display Units Menu
(
C_F
) select ° C (
C
). Press
Advance
.
8.
In the
Range Low Menu
(
r.Lo
) select desired range. This setting may be adjusted by the
user to fit their chosen specification. V-TEK presets the low range at
100
(
100
). Press
Advance
.
9.
In the
Range High Menu
(
r.Hi
) select desired range. This setting may be adjusted by the
user to fit their chosen specification. V-TEK presets the high range at
200
(
200
). Press
Advance
.
Temperature Display Set Point Display
Up & Down Keys
Advance Key
Infinity Key
Summary of Contents for TM-500
