Triumph Tiger Explorer XR 2016, Service Manual

Page: 253 / 750

Oxygen sensor adaption status (off idle) %
Oxygen sensor adaption status (idle) %
Function Tests
The system allows the diagnostic software to perform a series of function tests on various actuators in the
engine management system. In some cases it is necessary to make a visual observation of a component and in
others, if faults are present, DTCs will be logged.
The Function Tests available are:
Function Examined Report Method
Instrument panel Observe instrument panel, refer to Service Manual
Idle air control stepper motor Observe throttle position/Stored fault code*
Purge valve Listen for valve operation/Stored fault code*
Secondary air injection Listen for valve operation/Stored fault code*
Ride by wire motor open/closed Observe throttle position/Stored fault code*
Cruise control switch check Operate the cruise control switches as instructed. Observe the relevant
switch response and rectify as necessary
* If a fault is detected.
Adjust Tune
Using the Triumph diagnostic software, it is possible to:
Reset the adaptions
Balance the throttle bodies.
To reset the adaptions, see Engine Management Adaption.
To balance the throttles, see Throttle Body Balancing.
Freeze Frame Data
Freeze frame data is stored at the time a DTC is recorded (confirmed) by the ECM. If multiple DTCs are
recorded, the freeze frame data which is stored will relate to the first recorded DTC only.
By calling up freeze frame data associated with the first recorded DTC, the technician can check the engine
condition at the time the fault occurred. The data available is:
Function Examined Report Method
DTC Diagnostic Trouble Code (DTC)
number
Fuel system status open or closed loop operation
Calculated load %
Tiger Explorer XR Series
249 of 746
FUEL SYSTEM / ENGINE MANAGEMENT