Triumph Tiger Explorer XR 2016, Service Manual

Page: 536 / 750

Test Result Action
speed sensor between the sensor and
the pulser ring:
- Air gap between 0.1 mm to 1.5 mm
Faulty Rectify the fault and proceed to test 4
3 Check the wheel speed sensors for
correct installation, and the fixings for
correct torque OK Proceed to test 4
Faulty Rectify the fault and proceed to test 4
4 Clear fault code and test ABS to verify
fault cleared OK Action complete - quit test
Fault still present Contact Triumph service
Motor - Lock; Motor Does Not Run; Motor Runs Continually
Fault Code Possible Cause Action
Motor circuit fault Motor circuit fault Ensure ABS ECM connector is
secure
Turn the ignition 'ON'
Proceed to pinpoint test 1:
Motor - does not run Motor - does not run
Motor - runs continually Motor - runs continually
Pinpoint Tests
Test Result Action
1 Check ABS fuse integrity OK Proceed to test 2
Faulty Replace fuse and proceed to test 5
2 Check the motor function:
Check that with the motorcycle
stationary and the ABS ECM
modulator connected, the motor does
not operate OK Proceed to test 3
Motor runs
continually Contact Triumph service
3 Check cable continuity: With Ignition
'ON', check voltage between:
- ABS ECM connector pin 1 and
ground pin 13 Voltage greater
than 10 V Proceed to test 4
Voltage less than
10 V Locate and rectify wiring fault, proceed
to test 5
4 Check cable for continuity:
- ABS ECM connector pin 13 and
Ground OK Proceed to test 5
Faulty Locate and rectify fault, proceed to test 5
5 Reconnect ABS ECM harness, clear
fault code and test ABS to verify fault
cleared OK Action complete - quit test
Fault still present Contact Triumph service
Tiger Explorer XR Series
532 of 746
BRAKES