Triumph Tiger Explorer XR 2016, Service Manual

Page: 701 / 750

Fault Code Possible Cause Action
Erase stored DTCs from all ECMs
Fault Code Possible Cause Action
C1131 Rear preload motor minimum end
stop detection error. Preload
motor not inhibited. Rear preload motor calibration is
started automatically after next
ignition cycle
Allow rear preload motor to
calibrate, see Rear Suspension
Unit Preload Motor Calibration
C1132 Rear preload motor minimum end
stop detection error. Preload
motor inhibited.
C1133 Rear preload motor Maximum end
stop detection error. Preload
motor not inhibited.
C1134 Rear preload motor Maximum end
stop detection error. Preload
motor inhibited.
Chassis Electronic Control Module (ECM) - Removal
WARNING
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Remove the rider’s seat (see Rider’s Seat - Removal).
Disconnect the battery, negative (black) lead first.
Release the wing nut and remove the chassis ECM cover.
1.
1
2
Wing nut 1.
Chassis ECM cover 2.
Disconnect the chassis ECM connectors (see Chassis ECM Connectors). 2.
Remove the chassis ECM from the under seat tray. 3.
Tiger Explorer XR Series
697 of 746
ELECTRICAL