Triumph Tiger Explorer XR 2016, Service Manual

Page: 486 / 750

Note
be repeated.
Slowly depress the brake pedal and, holding the pedal fully down, close the bleed nipple. 6.
Repeat steps 5 and 6 for the duration of bleed stages 1 and 2. 7.
Note
Maintain the brake fluid level between the upper and lower reservoir levels whilst bleeding is being
carried out.
Once the bleed sequence has completed the diagnostic tool will display a message 'ABS system bleed
complete' . Note that this message may take a few seconds to appear after the ABS modulator has become
silent.
8.
Apply pressure to the brake lever and close the bleed nipple. Tighten the nipple to 6 Nm . 9.
Final Steps
WARNING
Use only DOT 4 specification brake fluid as listed in the General Information section of this manual. The use
of brake fluids other than those DOT 4 fluids listed in the General Information section may reduce the
efficiency of the braking system leading to loss of motorcycle control and an accident.
Observe the brake fluid handling warnings given earlier in this section of the manual.
WARNING
It is dangerous to operate the motorcycle with defective brakes; you must have your authorised Triumph
dealer take remedial action before you attempt to ride the motorcycle again. Failure to take remedial action
may reduce braking efficiency leading to loss of motorcycle control and an accident.
CAUTION
To prevent paint damage, do not spill brake fluid onto any area of the bodywork. Spilled brake fluid will
damage paintwork.
Ensure both manual and ABS system bleed procedures have been completed and repeated in the sequence
described at the beginning of the Core Activity section.
In the Triumph diagnostic software, navigate to ENGINE DIAGNOSTICS - FUNCTION TEST and perform
the cruise control switch check (see Cruise Control Switch Check) to ensure correct brake switch operation.
Disconnect the Triumph diagnostic tool.
Fill the reservoir to the maximum level with new DOT 4 fluid.
Fit the reservoir cover and diaphragm. Check for correct diaphragm fitment before final tightening of the
cover.
Remove the bleed tube from the nipple.
Replace the bleed nipple cap.
Refit the heel guard and tighten its fixings to
7 Nm .
Check for correct brake operation. Rectify as necessary.
Rear Brake Pads - Removal
WARNING
Before starting work, ensure the motorcycle is stabilised and adequately supported. This will help prevent it
from falling and causing injury to the operator or damage to the motorcycle.
Tiger Explorer XR Series
482 of 746
BRAKES