Triumph Tiger Explorer XR 2016, Service Manual

Page: 471 / 750

Remove the clip from the brake pad retaining pin. 1.
While pressing down on the anti
‑
rattle spring, remove the brake pad retaining pin. 2.
2
3
1
Clip 1.
Anti ‑ rattle spring 2.
Brake pad retaining pin 3.
Collect the anti
‑
rattle spring. 3.
CAUTION
In the following operation, never lever directly against the disc, caliper or pad lining material. Always use a
levering tool made from a soft material that will not cause damage to the load bearing surfaces.
Brake fluid will be displaced as the caliper pistons are compressed. To prevent body damage, ensure that the
displaced fluid does not come into contact with any part of the bodywork.
Carefully push the brake pads apart to force the caliper pistons back to allow withdrawal of the pads. 4.
Note
Complete the installation of the brake pads to one caliper (see Front Brake Pads - Installation) before
removing the pads from the other caliper.
Front Brake Pads - Inspection
Front Brake Pads - Installation
Check the brake pad retaining pin, retaining pin clip and anti
‑
rattle spring. Renew any component which
shows signs of damage and corrosion.
1.
Inspect the brake pads for wear (see Brake Wear Inspection). 2.
WARNING
Never use mineral-based grease (such as lithium or copper based grease) in any area where contact with
the braking system hydraulic seals and dust seals is possible. Mineral-based grease will damage the
hydraulic seals and dust seals in the calipers and master cylinders.
Damage caused by contact with mineral-based grease may reduce braking efficiency resulting in loss of
motorcycle control and an accident.
Fit new brake pads as an axle set or, if all the pads are in a serviceable condition, clean the pad grooves
before refitting all pads in their original positions. 1.
Tiger Explorer XR Series
467 of 746
BRAKES